Retaining Cap & Jet Sleeve (type 4) for TRG col Wire and Connectors Guaranteed performance up to 1200W

Guaranteed performance up to 1200W (or your money back)

Rotor packing set

These marine brass sleeve bearings (referred to as both cutless and cutlass) are used in the following products from October 2016:

A pressure sensor

Retaining Cap & Jet Sleeve (type 4) for TRG col Wire and Connectors Guaranteed performance up to 1200WWe advise every PowerSpout TRG owner to have one of these spare. A common need for replacement is the retaining cap being installed incorrectly (not greased and hand tight) causing damage to the thread when the cap comes off the sleeve under pressure. Includes: 1 x Jet sleeve and O ring 1 x Jet retaining cap The jet sleeve has a male 50mm (2" BSP) thread suitable for assembly with a valve or camlock fitting. This thread is not visible in the rendered